GOVECS Schwalbe - Powerland Charger Process

The LED light on the charger indicates the current status of the charging process:
To ensure that your Schwalbe is charged correctly, you will find the individual steps for the charging process here:
01
A B
D
02 03
Switch off your Schwalbe
and remove the key from the
ignition. Wait 60 seconds. 2.
RED LIGHT:
Charging in progress
GREEN FLASHING:
Connection is being
established and ready
for charging
GREEN LIGHT:
Batteries are fully
charged
NO LIGHT:
No AC input / AC
undervoltage
RED FLASHING:
process fault
Connect the charging cable
to the Anderson plug in
your Schwalbe. You will find
the Anderson plug in the
compartment under the seat.
Plug the power cable into
the socket. The charger
starts automatically once
connected to the AC socket.
C
E
EN
Give your Schwalbe the power it needs
YOUR SCHWALBE IS EQUIPPED WITH AN EXTERNAL POWERLAND AC/DC CHARGER.
79
YOUR SCHWALBE