Maintenance and Adjustment
• Pay attention not to make scratches when cleaning the headlight and those plastic parts. Avoid using
high-pressure water spray where seals and electric components are, water seepage can cause damage.
• Make sure not to spray water to clean the following delicate parts: airbox, ECU, brakes, all electric
connectors, muffler hole, fuel tank cap.
• First, rinse away the dust and remove dirt with water.
• Mix the cleaning agent and water to the proportion, use soft clean cloth or sponge to gently rub the
bike.
• Rince off with soft- or foggy-spray of clean water
• Wipe with soft cloth to dry and see if all dirt is gone
• Air blower is not recommended to dry your bike, it may cause flaws to the paint finished
• Restart the engine at and run idle speed to warm up
• Ride slowly after washing. Check both brakes by squeezing front and stamping rear brakes several
times to help dry the pads.
34
To Next Page
