Questions – service@automaticsolutions.com.au
LOGICID120
• TIP – You need to fit three small loops of wire to your safety inputs to make anything work. These
can be removed later if you install safety devices to these input terminals. But for now take three
pieces of light gauge wire (speaker or telephone wire is good) about 50mm long and strip both ends
7mm and insert them as above from 6 to 9, 8 to 9 and 12 to 13.
• TIP – The manual offers both automatic programming and manual programming. Manual
programming gives more control and is preferred by professional installers, but auto programming
works just fine so give it a try first.
• TIP – This control board has a higher level of security than previous versions and will not accept
older style remote controls. Use REMGR only.
• TIP – If using wireless keypad KEYPADP6 set it to 20Bit mode to work with this board.
To Next Page
Need help?
General
