Grabo Pro Lifter 20 - Spare Parts; Declaration of Conformity

23
GRABO PRO-LIFTER 20 | Operator’s manual
The device is now calibrated and the values in the digital display window should be correct.
NOTICE: The GRABO® Pro-Lifter20 will display incorrect values on the digital display if
the device is not calibrated on a non-porous surface such as tile or glass. In this case the
calibration process must be repeated on a non-porous material. DO NOT perform this process
on glass that is thinner than 6mm. Glass thinner than 6mm may be damaged.
DISPOSAL
Do not dispose of electric equipment, batteries, accessories, and packaging in domestic waste
in observance of the European Directive 2012/19/EC on waste of electrical and electronic
equipment and its implementation in accordance with national law. Electrical equipment that
has reached the end of its life shall be collected separately and returned to an environmentally
compatible recycling facility. The WEEE symbol ➍ will remind you of this when the need for
disposal occurs.
SPARE PARTS
Name Article number
GRABO® Pro-Lifter20
GP
Battery
TB05000
Multi-socket battery charger
SP94112
Rubber foam seal
RK13001
Fabric bag
SN23017
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product, the GRABO® Pro-Lifter20,
Model No. NG-Pro-14.8-2Li and GP-1Li-FB-1S, is in conformity with the following standards
or standardized documents: EN 55014-1:2017, EN 55014-2:2015, in accordance with the
provisions of the directives 2014/30/EC, 2006/42/EC, 2011/65/EU.
Technical le at: Nemo Power Tools
Name: Nimo Rotem
Date: 10/11/2021
Signature