7
QUICKSTART GUIDE - 1st time set up
What you need before you can use your Internet Radio:
A broadband internet connection is required.
A wireless (Wi-Fi) modem or router connected to your broadband (cable or DSL) internet.
NOTE: IF your wireless (Wi-Fi) network is password protected (WEP or WPA), please obtain your
password before proceeding to Step 1. All passwords are UPPER and lower case sensitive.
Step 1: Plug the round jack from the power cord into the back of the radio and the other end into a wall
outlet. On the front of the radio press the power switch to turn the radio “ON” (If the clock is on the
display the radio is in standby mode). The main screen will display and within approximately 4 seconds
will flash a series of messages. The messages that are briefly displayed will be ‘Grace Digital Audio’,
‘Starting…’ then ‘Scanning’.
NOTE: If your radio does not automatically start scanning when plugged into power the 1
st
time, please
press the ‘Power’ button on the bottom right of the front of the radio to turn your radio on and to view the
main radio menu. Press the ‘Home’ button located at the top middle of the front panel. This button
can be easily identified by the symbol of a house. This button will always return you to the main menu.
Turn the Menu knob on the front of the radio to right until the ‘Settings’ icon is highlighted. Now press
the Menu knob inwards to select ‘settings’.
To Next Page
Loading...
Need help?
General
