To Next PageTo Next Page
Need help?Do you have a question about the Graco 24Y175 and is the answer not in the manual?
General| Model | 24Y175 |
|---|---|
| Category | Water Pump |
| Maximum Air Input Pressure | 100 psi |
| Air Inlet Size | 1/4 in |
| Power Source | Pneumatic |
High-pressure fluid can pierce skin, causing serious injury and potential amputation. Seek immediate surgical treatment.
Flammable fumes can ignite or explode. Ensure ventilation and eliminate ignition sources.
Misuse can cause death or serious injury. Do not exceed ratings, operate when fatigued, or use incompatible fluids.
Moving parts can cause pinching, cutting, or amputation. Keep clear of moving parts.
Equipment surfaces and fluid can become very hot. Avoid touching hot fluid or equipment.
Toxic fluids or fumes can cause serious injury or death. Read SDS and wear appropriate PPE.
Always wear appropriate PPE to prevent serious injury, including respirators, gloves, and eyewear.
Relieve pressure before stopping spraying, cleaning, checking, or servicing equipment to prevent injury.
Follow pressure relief procedure, shut off pumps, and disconnect power before disassembly.
Step-by-step instructions for disconnecting fluid inlet, outlet, and tubes for Pump A.
Step-by-step instructions for disconnecting fluid inlet, outlet, and tubes for Pump B.
Detailed steps for removing the packing wet-cup assembly from Component A pumps.
Steps to remove packing nut, retaining ring, and felt washers from Component B pumps.
Steps to install the ball, u-cup, and bushing onto the pump rod during reassembly.
Instructions for installing the piston and applying the specified torque.
Steps for screwing the pump into the housing, aligning parts, and tightening the locknut.
Detailed steps for screwing Pump A into housing, applying sealant, connecting fittings, and priming.
Key technical specifications including working pressure, displacement area, fluid inlet/outlet sizes, and materials.
