5309286
Shipping Damage
Check the pressure washer for shipping damage. Notify the carrier immediately if there is any damage.
Setup
Connect High–Pressure Hose and Gun
Connect the high–pressure hose between the pump outlet and gun inlet.
Both of these connections are made with quick couplers.
Install Spray Tip
Install the spray tip on the wand. Installing and Changing Spray Tips, page 15). If you are using a Sandblast-
ing Kit, see its separate manual for installation instructions.
Up to 100 ft (30 m) of 3/8” high–pressure hose may be used. Longer hoses could affect pressure
washer and chemical injector performance balance.
CAUTION
To Next Page
Loading...
