6 309286
Connect to Water Supply
CAUTION
Before you connect the garden hose to the pressure washer, check your local plumbing code regarding
cross–connection to the water supply. If required, install a backflow preventer.
If the inlet water pressure is over 60 psi (4.1 bar), a regulating water valve must be installed at the garden
hose connection.
Do not exceed 160_F (70_C) inlet water temperature.
NOTE: The water source must have a minimum flow rate equal to that of the pressure washer.
Connect hose with at least a 3/4–in (19 mm) ID
from the water supply to the 3/4–in garden hose
inlet on the pressure washer. The supply hose
should not be more than 50 ft (15 m) long.
To Next Page
Loading...
