Service
Reel Spring
1. Relieve
the pressure
, and disconnect the inlet
hose from the reel.
INJECTION HAZARD
T
o reduce the risk of serious injury
whenever you are instructed to relieve
pressure, always follow the
Pressure
Relief Procedure
on page 12.
WARNING
2.
If the hose reel is mounted overhead, remove it
from its mounting surface and take it to a work
bench for further repair.
3.
Fully extend the service hose (48), and latch the
hose reel.
4.
Attach a C-clamp (B) to the hose reel flange to
help prevent the reel from unintentionally
becoming unlatched and spinning freely
.
See Fig. 16.
WARNING
Never
allow the reel to spin freely
. Doing so causes
the hose to spin out of control, which could cause
serious injury if you are hit by the hose.
5.
Disconnect and remove the service hose (48).
Fig. 16
A
40
48
22
B
03723A
6.
Carefully remove the C-clamp (B).
7. W
earing heavy gloves, hold the reel with both
hands and let it slide slowly through your hands
until the reel stops. See Fig. 16. When the reel
stops the spring tension has been released.
To Next Page
Loading...
