Table
of Contents
Installation
Typical 5.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Roller
Support Arm
7.
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Mounting
Options
8.
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing
a Hose
10.
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Increasing
Spring T
ension 11.
. . . . . . . . . . . . . . . . . . . .
Maintenance 12
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service 14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts
Low/Medium
Pressure
18.
. . . . . . . . . . . . . . . . . . . . . . .
High
Pressure
20.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessories 22
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical
Data
25.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dimensions 25
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The
Graco W
arranty and Disclaimers
28.
. . . . . . . . . . .
Graco
Phone Number
28.
. . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This
symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This
symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
EQUIPMENT MISUSE HAZARD
Equipment
misuse can cause the equipment to rupture or malfunction and result in serious injury
.
D
This equipment is for professional use only
.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor
.
D
Do not alter or modify this equipment. Use only extensions that are designed for use with your
dispensing valve. Modifying parts can cause a malfunction and result in serious bodily injury
.
D
Check equipment daily
. Repair or replace worn or damaged parts immediately
.
D
Do not exceed the maximum working pressure of the lowest rated system component. The
maximum working pressure of your hose reel assembly is indicated on the hose reel identification
plate on the reel pedestal. See also the
T
echnical Data
section on page 25.
D
Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the
T
echnical Data
section of all equipment manuals. Read the fluid and solvent manufacturer
’s
warnings.
D
Do not use hoses to pull equipment.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose hoses to temperatures above 82
_
C (180
_
F) or below –40
_
C (–40
_F).
D
Do not lift pressurized equipment.
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
D
If you are adding a service hose and dispensing valve to a bare hose reel, be sure you know the
maximum working pressure of all the components.
D
Never use a low-pressure flexible extension designed for low-pressure dispensing valves or
hand-powered lubricating equipment on a medium- or high-pressure dispensing valve.
To Next Page
Loading...
