Graco 3A0243A - Page 27

Hose Reel
3A0243A 27
Installation
1. Grease shaft.
2. Make sure two washers and wave spring are on hub
before hose reel is installed.
3. Install hose reel onto frame. Place C-clamp on reel
and frame to allow snap ring to fit into place. Install
snap ring.
4. Install swivel cap.
5. Install E-clip.
6. Install hose to hose cap. Make sure to route hose
through side arm of hose reel.
7. Wrap up hose. Make sure hose is routed through
hose guide.
ti13537a
ti13545a
ti13536a
ti13543a
ti13538a
ti15023a
ti13504a