Setup
332689D 15
9. Move Prime/Spray Valve to PRIME.
10. Plug sprayer in a grounded outlet.
11. Push pump priming button two times.
12. Turn power switch ON.
13. Align setting indicator with Prime/Clean setting on
Pressure Control knob until pump starts, page 13.
14. When sprayer starts pumping, water and air bub-
bles will be purged from system. Allow fluid to flow
out of prime tube, into waste pail, for 30 to 60 sec-
onds.
15. Turn power switch OFF.
16. Transfer suction tube to paint pail and submerge
suction tube in paint.
17. Turn power switch ON.
To Next Page
Loading...
