Spraying
24 3A6342A
Spraying
Start
1. Turn pressure control knob to SPRAY
position.
2. Disengage Trigger Lock.
Adjust Pressure Control
1. For best spray results with lowest
overspray, begin with the Pressure
Control Knob adjusted to the lowest
spray setting.
2. If needed, increase Pressure Control
Knob setting to the lowest spray setting
that results in an acceptable spray
pattern.
Spray Pattern Quality
A good spray pattern is evenly distributed as
it hits the surface.
• Spray should be atomized (evenly
distributed, no gaps at edges).
• Increase Pressure Control Knob if
needed until spray is even and without
gaps at edges.
• Spray Tip may be worn or a smaller tip
may be needed. See Spray Tip and
Pressure Selection, page 23.
• Material may need to be thinned. If
material needs to be thinned follow
manufacturer’s recommendations.
To Next Page
Loading...
Need help?
General
