Table
of Contents
Warnings 2.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Mounting
Hole Layouts
5.
. . . . . . . . . . . . . . . . . . . . . . . . .
Dimensional
Drawing
5.
. . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air
Motor Service
8.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical
Data
6.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts
Drawings and Lists
Model 207–546
12.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Model
206–955
13.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Models
205–997, 215–363, 945–997
and 222–791
14.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessories 15
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco
W
arranty 16.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco
Phone Number
16.
. . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This
symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This
symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment
misuse can cause the equipment to rupture or malfunction and result in serious injury
.
D
This equipment is for professional use only
.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor
.
D
Do not alter or modify this equipment.
D
Check equipment daily
. Repair or replace worn or damaged parts immediately
.
D
Do not exceed the maximum working pressure of the lowest rated component in your system. This
equipment has a
180 psi (12 bar
, 1.2 MPa) maximum incoming air pressure.
D
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the
Tech-
nical Data
section of all equipment manuals. Read the fluid and solvent manufacturer
’
s warnings.
D
Do not use hoses to pull equipment.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 180
_F (82_
C) or below –40
_F (–40_C).
D W
ear hearing protection when operating this equipment.
D
Do not lift pressurized equipment.
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
To Next Page
Loading...
Need help?
General