9306982
Service
6. Grip the toggle rockers (S) with a pliers. Compress
the springs (T) and swing the toggle assembly (E)
up and away from the piston lugs (U), and remove
the parts. Check that the valve actuator (V) is
supported by the spring clips (W), but slides easily
into them. See Fig. 3.
7. Remove the trip rod yoke (K), valve actuator (V)
and trip rod (H). Check the exhaust valve poppets
(X) for cracks.
NOTE: To remove the exhaust valve poppets (X),
stretch them out and cut with a sharp knife.
8. Pull the piston (Y) up out of the base (J) and
inspect the piston o-ring (AA) and the o-ring in the
base casting.
Cut off tops of
poppets (x) as
indicated by dotted
lines
0.125 in.
(3.18 mm)
CUTAWAY VIEW
Fig. 3
E
Push toggles (E) in
and then up.
Turn wires up.
U
HK
L**
M**
O**
P**
Y
J
T
S
W
X**
V
Q**
R**
H
W
V
X**
O**
M**
P**
Q**
AA**
Y
R**
N
To Next Page
Loading...
