79
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt webbing and
cannot, by itself, hold the belt snug around a car seat.
Slowly pull the shoulder belt all the way out. Route
the vehicle seat belt through the proper belt path and
buckle it in. Then, as you pull the vehicle seat belt tight,
feed all the slack back into the retractor.
Grab the sides of the seat at the belt path and slide the
seat side-to-side and front-to-back. The seat should not
move more than 2.5 cm (1 in.).
To Next Page
Loading...
