Graco XP-H Series Instructions

Important Two-Component Material Information
8 3A0420V
Changing Materials
• Changing material types used in your system
requires special attention to avoid equipment dam-
age and downtime.
• Always clean the fluid inlet strainers after flushing.
• When changing between epoxies and urethanes or
polyureas, disassemble and clean all fluid compo-
nents and changes hose sets.
• Check with your material manufacturer for chemical
compatibility.
• Most materials use ISO on the A side, but some use
ISO on the B side.
• Epoxies often have amines on the B (hardener)
side. Polyureas often have amines on the B (resin)
side.
A and B Component Designations
Material suppliers and markets refer to plural component materials differently. The table below summarizes the differ-
ent designations for the components used in various machines.
Market Equipment Designations
Machine Left
Side
Machine Right
Side
Foam and Polyurea, and
Urethane Pour
All Reactors, HFR
™
,
and VRM
™
Letter
AB
Color
Red Blue
Component Names
ISO, Hardener,
Catalyst
Polyol, Resin,
Base
Major or Minor Component
(when not 1:1 mix)
Low Volume
Side
High Volume
Side
Epoxy and Urethane
Protective Coatings
Hydra-Cat
®
, Xtreme-
Mix
™
, XM
™
, and XP
Letter
AB
Color
Blue Green
Component Names
Resin, Base
Hardener, Cata-
lyst
Major or Minor Component
(when not 1:1 mix)
High Volume
Side
Low Volume
Side
Epoxy, Silicone, Ure-
thanes, and other mate-
rials
PR70
™
and PR
Letter
AB
Color
Red Blue
Component Names
Polyol, Resin,
Base
ISO, Hardener,
Catalyst
Major or Minor Component
(when not 1:1 mix)
High Volume
Side
Low Volume
Side

Graco XP-H Series Specifications

General

Brand	Graco
Model	XP-H Series
Category	Airbrushes
Language	English