Graef ES 70 - Unpacking; Requirements for the installation location; Using the control panel

6
EN
water(withoutcoffeegrounds)tothoroughlyushthesystem.Proceedasdescribedinthe„Prepa-
ring espresso“ section.
Unpacking
To unpack the unit, proceed as below:
•Take the unit out of the carton.
•Remove all pieces of the packing.
•Remove any possibly extant labels on the unit. (not the rating plate).
Requirements for the installation location
Forsafeandawlessoperationoftheunit,theplaceoflocationmustmeettheseprerequisites:
•The unit must be set up on a firm, flat, level, non-slip and heat resistant base that has sufficient load
bearing capacity.
•Select the place of location so that children cannot reach the hot surfaces of the unit.
•The unit is not intended for installation in a wall or a built-in cupboard.
•Do not set up the unit in a hot, wet or moist environment.
•The electric socket must be readily accessible so that the power cord can be easily unplugged.
Using the control panel
POWER
Pressthe„POWER“buttononcetoturntheuniton.
Thelightbehindthe„POWER“buttonwillilluminateredandstartashing,thisistoindicatethat
your unit is on and heating up.
If the light turns to a constant green light, this indicates that the unit is heated and ready for use.
Before activating the espresso coffee function ensure that the steam and hot water control dial is in