Graef MS 701 - Unpacking; Requirements on the Installation Location

15
DE
EN
FR
NL
IT
• Do not move the unit while it is switched on. While moving, hot
liquid can escape from the unit.
• Do not use the stainless steel tank while on a hot plate or cooking
plate. Use the stainless steel tank only in connection with the base
station.
• Never touch rotating parts of the unit.
• Never leave the unit unsupervised during operation.
• Fill the unit only up to the MAX mark. If overlled, hot liquid can
escape from the tank.
• Let the unit cool off before cleaning.
• Switch the unit off before cleaning and pull the power cord from
the electric socket.
• Never immerse the base unit, the connection cable or the connec-
tion plug into water or any other uid.
• Do not clean the base unit in the dishwasher.
UNPACKING
Proceed as follows to unpack the unit:
• Pull the unit out of the cardboard box.
• Remove all packaging and possible stickers on the unit (do not re-
move the name plate).
REQUIREMENTS ON THE INSTALLATION LOCATION
For safe and fault-free operation of the unit, the following has to
observed during installation:
• Use a rm, even, horizontal, non-slip and heat resistant surface
with a sufcient load capacity.
• Select an installation location in such a way that children cannot
reach any hot surfaces of the unit.
• The unit is not designed for installation in a wall or a built-in cup-
board.
• Do not set up the unit in a hot, wet or moist environment.
• The power outlet must be easily accessible so that the power cable
can be quickly removed in case of emergency.