Graef UNA 9 - Requirements for Location; Electrical Connection

Universal Slicer UNA 9
© Gebr. Graef GmbH & Co. KG
19
EN
important!
► If possible, keep the original
packaging for the duration of
the warranty period in order to
be able to package the device
properly if needed for the
guarantee.
Requirements to the loca-
tion of set-up.
The place of set-up must meet the
following requirements for a safe
and faultfree operation of the de-
vice:
■ The device must be set up on a
rm, at, level and non-slip sur-
face with sufcient weight-bea-
ring capacity.
■ Choose the place of set up such
that children cannot reach the
sharp knife of the device.
Electrical connection
When connecting the device with
electricity, please adhere to the fol-
lowing notices for a safe and fault-
free operation of the device:
■ Compare the connecting data
(voltage and frequency) on the
type plate with those of your po-
wer grid prior to connecting the
device. This data must correspond
to avoid damages to the device. In
case of doubt, ask your electrici-
an.
■ Make sure that the connecting
line is not damaged and is not lain
over hot surfaces or sharp edges.
■ The connecting cable may not be
pulled tightly.
■ The electrical safety of the device
is only then given if it is connec-
ted to a properly installed protec-
tive earth system. Operation on
a power socket without protecti-
ve earth is prohibited. In case of
doubt, have the house installation
inspected by an electrician. The
manufacturer assumes no liability
for damages that are caused by a
lacking or interrupted protective
earth.