Why does my Gram OM 6210-90 T/1 Dishwasher programme not start?
If your Gram Dishwasher isn't starting, several factors could be at play. First, ensure the dishwasher is properly plugged in and switched on using the On/Off button. Check your indoor fuses and make sure the water inlet tap is open. The dishwasher door needs to be fully closed to start. Finally, inspect the water inlet hose and machine filters for any clogs.
What to do if partial food wastes remain on dishes after using Gram OM 6210-90 T/1?
If your Gram Dishwasher is leaving partial food wastes on the dishes, there are several potential causes. Make sure that you are not overloading the baskets and that dishes aren't leaning against each other. Ensure you're using enough detergent and selecting the appropriate wash program. Also, check the spray arms for clogs and verify that the drain hose and filters are correctly fitted.
What to do if water remains inside Gram OM 6210-90 T/1?
If water remains inside your Gram Dishwasher, start by checking the drain hose for any clogs or twists; clean or untwist it as needed. Next, inspect the filters for clogs and clean them thoroughly. Finally, ensure that the wash cycle has fully completed.
How to remove whitish stains from dishes after using Gram OM 6210-90 T/1 Dishwasher?
If you notice whitish stains on your dishes after using the Gram Dishwasher, it could be due to several reasons. Ensure you're using the correct amount of detergent. Also, your rinse aid dosage and/or water softener setting might be too low, so try increasing those levels. If you have hard water, increase the water softener level and add salt. Lastly, verify that the salt compartment cap is closed properly.
How to prevent rust stains on dishes from Gram OM 6210-90 T/1?
Rust stains on dishes from your Gram Dishwasher can be caused by a few things. The stainless-steel quality of your dishes might be insufficient, so ensure you're using only dishwasher-proof sets. A high level of salt in the wash water can also cause rust, so adjust the water hardness level using the water hardness table. Make sure the salt compartment cap is closed properly and use a funnel when filling with salt to avoid spillage. Finally, a poor mains grounding could be the culprit; consult a qualified electrician immediately.
Why does my Gram OM 6210-90 T/1 stop during washing?
If your Gram Dishwasher stops mid-cycle, the issue might stem from a power failure, so check your mains power supply. Alternatively, there could be a water inlet failure; in this case, check the water tap to ensure it's open and supplying water.
Why are my dishes not drying in the Gram OM 6210-90 T/1 Dishwasher?
If your dishes aren't drying in the Gram Dishwasher, first check if you've selected a program with a drying option. If not, choose one that includes drying. Also, the rinse aid dosage might be set too low, so increase the rinse aid dosage setting.
Why is my Gram Dishwasher making shaking and hitting noises?
If you hear shaking and hitting noises during a wash cycle in your Gram Dishwasher, it's likely that the spray arm is hitting dishes in the lower basket. To resolve this, simply move or remove any items that are blocking the spray arm's movement.
Why does detergent remain in the detergent compartment of my Gram OM 6210-90 T/1?
If detergent remains in the detergent compartment of your Gram Dishwasher, it may be because the compartment was wet when you added the detergent. Ensure the detergent compartment is dry before adding detergent.
What to do if Gram Dishwasher has insufficient water?
If your Gram Dishwasher is showing signs of insufficient water, ensure that the water inlet tap is fully open and water is flowing freely. Also, separate the inlet hose from the tap and clean the filter of the hose to remove any potential blockages. If the issue persists after these steps, it is recommended to contact customer service for further assistance.
General| Brand | Gram |
|---|---|
| Model | OM 6210-90 T/1 |
| Category | Dishwasher |
| Language | English |
To Next Page
