Repair manual GRAMMER seat suspension MSG95EAC – November 2012
Material no. 1 277 338
3.14 Air distributor – removal and installation
Page 2 of 2
12 Pull off the quick-release fastener
screws (9, 10, 16) at the air hoses
(3, 6, 7).
Installation notes:
• Pull off the existing protective caps
(18) at the quick-release fastener
screws (9, 10, 16) which are
preassembled at the new air
distributor (1).
• Insert the air hoses (3, 6, 7) into the
quick-release fastener screws
(9, 10, 16) as far as possible, then
pull it back approx. 1 mm.
13 Press back the circlip (15) at the air
distributor (1) and pull the air hose
(2) out of the air distributor (1).
Installation note:
Insert the air hose (2) into the circlip
(15) of the air distributor (1) as far as
possible.
14 Pull the air hoses (12, 13, 14) out of
the aperture in the lower suspension
part (9) and remove them together
with the air distributor (1).
Installation notes:
• Before installation of the new air
distributor (1), push the new air hose
(12) completely onto the mandrel
profile (22) of the new air distributor
(1).
• Pull off the existing protective caps
at the air hoses (12, 13, 14) and at
the circlip (15).
15 Re-install the components in the
reverse order of their removal.
To Next Page
Loading...