Grammer MSG95EAC - Page 58

Repair manual GRAMMER seat suspension MSG95EAC – November 2012
Material no. 1 277 338
3.16 Cable harness for seat suspension – removal and installation
Page 1 of 2
Removal and installation
1 Remove the upper seat part at the seat
suspension (see Chapter 3.1).
2 Remove the top cover (see Chapter
3.2).
3 Remove the bellows at the upper
suspension part (see Chapter 3.4) and
press it down.
4 WARNING Risk of crushing!
Move the seat suspension to the
highest position and secure at the back
between the swinging structure and the
lower suspension part by means of
suitable spacers.
5 WARNING The pressure in the
pneumatic system may cause injury!
Vent the pneumatic system before
removing the cable harness for seat
suspension (1).
6 Remove the control / air reservoir and
put it aside (see Chapter 3.11).
Note:
The compressed-air hose and the
electrical connection do not have to be
removed from the control / air
reservoir.
7 Disconnect two electrical connections
(A and B) at the sensor module (5) and
remove two cable ties (see Chapter
3.9).
8 Disconnect two electrical connections
(G and H) at the compressor (see
Chapter 3.8).
9 Disconnect the electrical connection
(K) at the cable harness for vehicle
connection (see Chapter 3.12).
10 Disconnect the electrical connection
(C) at the control / air reservoir (see
Chapter 3.11).
11 Remove the cable tie (5) and
disconnect the air hose to the control
/ air reservoir at the quick-release
fastener (see Chapter 3.11).
12 Remove the air distributor at the
lower part of the suspension and
disconnect the electrical connection
(F) (see Chapter 3.14).
13 Remove the plug (8) at the air
distributor (see Chapter 3.14).
14 Pull off two air hoses (9) at the air
distributor (see Chapter 3.14).
2872
1
4
7
10
5
6
5
K
F
H
G
F
B
A J
I
C
6
10
3
2
8
9