To Next PageTo Next PageWhat to do if pilot is on but no main burner on GRAND EFFECTS 100?
If the pilot light comes on but the main burner of your GRAND EFFECTS Outdoor Fireplace doesn't, first check if the main gas solenoid is energizing. If you can't confirm this, replace the ignition module. If the main burner solenoid is buzzing or shows signs of overheating, it may need to be replaced.
Why does my GRAND EFFECTS 100 burner keep going on and off?
If your GRAND EFFECTS Outdoor Fireplace burner goes on and off, check the following: * If wind is the reason for this issue, rotate the burner assembly so the wind isn't blowing across the pilot. * If you are using glass, make sure you are using an open pilot hood and that the glass is thinned down on the burner assembly. Also, remove rock/glass away from pilot area. * Remove all rock/glass from the burner assembly to see if the problem disappears. * Ensure that the gas pressure isn't too low and the main burner isn't adjusted too low, as this can cause an unstable pilot. * If the burner shuts off after 30 minutes and doesn't come back on, replace the ignition module.
How to fix main burner on GRAND EFFECTS 100 Outdoor Fireplace when it does not light (no spark)?
If the main burner of your GRAND EFFECTS Outdoor Fireplace isn't lighting and there's no spark, start by removing any rock or glass from the pilot area that might be obstructing it. If there's still no spark, check that you have 12VAC coming out of the panel and reaching the burner. If voltage is going to the burner but there's no spark, replace the ignition module. If there's no voltage coming out of the panel, replace the transformer.
General| Brand | GRAND EFFECTS |
|---|---|
| Model | 100 |
| Category | Outdoor Fireplace |
| Language | English |
