GRP260x Administration Guide
Version 1.0.3.42
while a call is in progress.
Configures the phone to ring instead of playing call waiting tone when handset
or headset is used.
Configures the delay for automatically answering the incoming call. Valid range
is 0 to 10 (seconds).
Enable In-Call DTMF
Display
When set to "No", the DTMF digits entered during a call will not be displayed
on LCD.
Enable Sending DTMF via
specific MPKs
Allows certain MPKs to send DTMF in-call. This option does not affect Dial
DTMF. This option is available for the GRP2604 only.
If enabled, phone will show the duration of holding a call on the LCD.
If enabled, phone will be automatically unmuted when user resumes a call or
establishes a new call.
In-Call Dial Number on
Pressing Transfer Key
Allows the user to configure the number to be dialed as DTMF when using the
TRANSFER button.
Note: A, B, C and D are supported to be sent as DTMF.
Enable busy tone remote
disconnect
If enabled, phone will play busy tone when call is disconnected remotely.
When this feature is disabled, the desk phone user cannot mute his/her
microphone during a call.
This option is to configure to enable call transfer feature
Hold Call before
Completing Transfer
When set to "No", phone will neither hold the current call-in transfer window nor
hold the call with the transfer target before referring the call in the attended
transfer.
If set to "Static", attended transfer can only be performed with established calls.
If set to "Dynamic", attended transfers can be performed with established calls
or be initiated during the transfer process. This option does not affect the user's
ability to perform blind transfers.
If set to "No", a user cannot turn on Do Not Disturb feature via MUTE key, MPK,
or menu on LCD
:Toggle the DND switch to activate/Deactivate the DND from the Web
interface
When DND is enabled, the phone will send the selected type of SIP message.