MANUAL CONFIGURATION
1. Use the information from the Add SIP Extension page (Figure 4-4) to enter the
following necessary information on “Account => Account 1” section of the
Grandstream Phone WebUI (Figure 4-8):
Account Active: Yes
Account Name: GrandstreamUser
SIP Server: Elastix Server’s IP Address (192.168.5.186 in this example)
SIP User ID: 100
Authenticate ID: 100
Authenticate Password: (‘h7Dka3Rf9si0t’ in this example)
Figure 4-8. Account
2. Once you have entered the required information, click on ‘Save and Apply’ button
located at the end of the page.
3. To check the correct registration of the phone, go to “Status” section. You should see
your phone registered (Figure 4-9). If the phone is not registered, make sure you’ve
entered the correct information.
To Next Page
Loading...
