AUTOPROVISIONING USING ELASTIX’S ENDPOINT
CONFIGURATOR
Note: Endpoint Configurator support available starting Elastix 2.5 RC
1. After installation, in the Elastix Web Interface go to “PBX => Batch Configurations
=> Endpoint Configurator”. See figure 4-10
Figure 4-10. Endpoint Configurator
2. Type the network address where the phone is located and click on the magnifying
glass. This will generate a list with all the phones available in that network. See
figure 4-11.
Figure 4-11. List of endpoints
3. In the row where the phone you want to autoprovision is located (find it according
to either its MAC or IP Address):
Mark the checkbox
From the drop-down list, select the correct Phone Model if it is not detected
automatically
Click on the link “[Configure x.x.x.x]” to set the parameters to configure the
phone.
4. After clicking in the configuration link, you will see a window with many tabs
according to what you want to configure. In this case we will configure a SIP
account. Go to the tab “Accounts” and drag the accounts you want to assign from
To Next Page
Loading...
