Grandstream Networks GXV34 Series Administration Guide

Table 25: Account/SIP/Special Features
Phone Settings Page Definitions
Phone Settings/General Settings
Basic Settings
Synchronization
Metaswitch server. The call forward function will take effect on the server side while the local call
forward function is not effective.
The default setting is “Disable”.
Enable BroadSoft Call
Park
Configures whether to send SUBSRCIRBE message to BroadSoft server to obtain Call Park
notifications.
The default setting is “No”.
Conference URI
Configures the network-based conference URI (the BroadSoft Standard). If it is configured, end user
needs to tap the N-way key during the conference to transfer the host to the remote media server.
Broadsoft Call Center
When enabled, Feature Key Synchronization will be enabled regardless of web settings. Default is
Disabled.
Hoteling Event Enables BroadSoft Hoteling Event feature. Default is Disabled.
Call Center Status
When set to “Yes”, the phone will send SUBSCRIBE to the server to obtain call center status. Default
is Disabled.
SCA
Enable SCA (Shared
Call Appearance)
Enables/disables the Shared Call Appearance (the Broadsoft Standard) feature for this account. If it
is set to “Yes”, the phone system can update and share account status with another device. The
default setting is “No”.
Note: The Enable SCA settings now supports provision via strings. The value “0” can be replaced
with “line”or “private”; value “1” can be replaced with “shared” or “sharedline”.
Enable Barge-in
Enables/disables the Barge-In feature. If it is set to “Yes”, the user could tap the SCA account to
barge into an active session with another shared line.
The default setting is “No”.
Line-seize Timeout
(s)
Configures the interval (in seconds) when the line seize is considered timed out when Shared Line
feature is used. Valid range is 15-60.
Call Park
Auto-filling CallPark
Feature Code
If it is set to “Yes”, the configured “Call Park Service Code” will be automatically filled in on the
phone’s dial pad when picking up the parked call. This option will be active only if “Special Mode” is
set to “Broadsoft” and “Enable SCA” is set to “Yes”.
The default setting is “Yes”.
CallPark Feature
Code
Configures the pickup feature code for call park. If ” Auto-filling CallPark Feature Code ” is set to
“Yes”, this call park service code will be automatically filled in on the phone’s dial pad when picking
up the parked call. This is used when “Special Mode” is set to “BroadSoft” (from web UI or
provisioning) and “Enable SCA” is set to “Yes”.

Grandstream Networks GXV34 Series Specifications

General

Brand	Grandstream Networks
Model	GXV34 Series
Category	Conference System
Language	English