LLDP TX Interval (s)
Configures the interval the phone sends LLLD-MED packet.
The default setting is 30s.
Enable CDP
Configures whether to enable CDP to receive and/or transmit information from/to CDP-enabled
devices.
The default setting is “Yes”.
Layer 3 QoS for SIP
Defines the Layer 3 packet’s QoS parameter for SIP messages in decimal pattern. This value is used
for IP Precedence, Diff-Serv or MPLS.
The default setting is 26 it is equivalent to the DSCP name constant AF31.
Layer 3 QoS for
Audio
Defines the Layer 3 packet’s QoS parameter for RTP messages in decimal pattern. This value is used
for IP Precedence, Diff-Serv or MPLS.
The default setting is 46 it is equivalent to the DSCP name constant EF.
Layer 3 QoS for
Video
Defines the Layer 3 packet’s QoS parameters for H.264 messages in decimal pattern. This value is
used for IP Precedence, Diff-Serv or MPLS.
The default setting is 34 it is equivalent to the DSCP name constant AF41.
HTTP/HTTPS User-
Agent
Sets the user-agent for phonebook and screen saver.
SIP User-Agent
Maximum
Transmission Unit
(MTU)
Sets the user-agent for SIP. Default is “Grandstream GXV34x0 $version”“$version” is replaced by
actual firmware version.
Configures the MTU in bytes. Please set MTU reasonably according to your needs.
Note: If MTU is set to less than 1280, IPv6 may not take effect.
PC Port Mode
PC Port Mode
Enables and defines the PC port mode. If it is set to “Mirrored”, the traffic in the LAN port will go
through PC port as well and packets can be captured by connecting a PC to the PC port. A reboot is
required to take effect.
The default setting is “Enabled”.
PC Port VLAN Tag
Defines the VLAN Identifier of the Layer 2 frame for PC port. This adds the VLAN tag value on the
target address received from the LAN port of the phone then sends the value to the device
connected to the PC port.
Note: VLAN tag value on the device connected to the PC port should be the same as the VLAN tag
value assigned to the PC port here.
PC Port Priority
Value
Determines the Priority Code Point within a Layer 2 frame header for PC port.
Proxy
HTTP/HTTPS Proxy
Hostname
Configures the HTTP/HTTPS proxy URI of the network. Some of networks requires going through a
proxy to access to the Internet.
The default setting is keeping this field blank.
HTTP/HTTPS Proxy
Port
Configures the HTTP/HTTPS proxy port number of the network. Some of networks requires going
through a proxy to access to the Internet.
The default setting is keeping this field blank.
Bypass Proxy For
Defines the specific URI that the phone can directly access to without HTTP/HTTPS proxy. If it is
filled, the phone will bypass the proxy to send the packets to the specific URI.
The default setting is filed blank.
Remote Control
CSTA Control
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the
system reboot to make it take effect.
Action URI Support Configures whether the phone is enabled to receive and handle Action URI request.
To Next Page
Loading...
Need help?
General
