FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 21 of 46
CONFIGURATION GUIDE
CONFIGURING THE HT802 THROUGH VOICE PROMPTS
DHCP MODE
Select voice menu option 01 to enable HT802 to use DHCP.
STATIC IP MODE
Select voice menu option 01 to enable HT802 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
UPGRADE PROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) Always check, 2) check when pre/suffix changes, and 3) never upgrade.
CONFIGURING THE HT802 VIA WEB BROWSER
HT802 has an embedded Web server that will respond to HTTP GET/POST requests. It also has
embedded HTML pages that allow users to configure the HT802 through a web browser such as
Microsoft’s IE, AOL’s Netscape or Mozilla Firefox installed on Windows or Unix OS. (Macintosh OS is not
included).
ACCESS THE WEB CONFIGURATION MENU
1. Find the IP address of the HT802 using voice prompt menu option 02.
To Next Page
Loading...
Need help?
General
