Grandstream Networks HT802 User Manual

FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 33 of 46
Offhook Auto-Dial
This parameter allows users to configure a User ID or extension number that is
automatically dialed when off-hook. Only the user part of a SIP address needs to be
entered here. The HT802 will automatically append the “@” and the host portion of the
corresponding SIP address.
Offhook Auto-Dial
Delay
The auto-dial delay after off hook.
Proxy-Require
SIP Extension to notify SIP server that the unit is behind the NAT/Firewall.
Use NAT IP
NAT IP address used in SIP/SDP message. Default is blank.
Use SIP User-Agent
Header
Configurable SIP User-Agent Header.
Distinctive Ring Tone
Custom Ring Tone 1 to 3 with associate Caller ID: when selected, if Caller ID is
configured, then the device will ONLY uses this ring tone when the incoming call is
from the Caller ID. System Ring Tone is used for all other calls. When selected but no
Caller ID is configured, the selected ring tone will be used for all incoming calls using
the FXS port or Profile. Distinctive ring tones can be configured not only for matching a
whole number, but also for matching prefixes. In this case symbol * (star) will be used.
For example:
if configured as *617, Ring Tone 1 will be used in case of call arrived from the area
code 617. Any other incoming call will ring using cadence defined in parameter System
Ring Cadence located under Advanced Settings Configuration page.
Note: If server supports Alert-Info header and standard ring tone set (Bellcore) or
distinctive ring tone 1-10 is specified, then the ring tone in the Alert-Info header from
server will be used. Bellcore rings and tones are independent from custom ring tones.
The custom ring tones can also be specified by alert-info header, for example
Alert-Info: <http://127.0.0.1>;info=ring5
Disable Call-Waiting
Default is No. If set to YES Call Waiting indication information will not be provided to
analog phone connected to this FXS port.
Disable Call-Waiting
Caller ID
Default is No. If set to YES Call Waiting caller ID will not be provided to analog phone
connected to this FXS port.
Disable Call Waiting
Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting
information arrives. The CWCID information will still be displayed.
Disable Receiver
Offhook Tone
Default is No. If set to yes, it will disable the warning to alert that the phone has been
left off-hook for an extended period of time.
Disable Reminder Ring
for On-Hold Call
Default is No. Do not play the reminder ring when this is set to Yes.
Disable Visual MWI
Default is No. If set to “Yes”, the MWI information will not be transferred to the analog

Grandstream Networks HT802 Specifications

General

Brand	Grandstream Networks
Model	HT802
Category	Adapter
Language	English