Need help?Do you have a question about the GRAPHTEC Craft ROBO CC100-20 and is the answer not in the manual?
General| Maximum Media Width | 210 mm |
|---|---|
| Connectivity | USB |
| Max Cutting Length | 1000 mm |
| Type | Cutting plotter |
| Interface | USB |
| Software Compatibility | ROBOMaster |
| Compatible Media | paper |
| Dimensions | 432 x 204 x 168 mm |
| Weight | 3.5 kg |
| Supported OS | Windows |
Step-by-step guide to removing and reattaching the left side panel of the unit.
Instructions for detaching and reattaching the top cover of the unit.
Guide for removing and reinstalling the main board, including cable disconnections.
Steps to update the device's firmware using software and a USB connection.
Detailed instructions for setting the pen force using the adjustment software.
Procedure for adjusting the sensitivity of the auto-registration mark sensor.
Steps to adjust the offset for the auto-registration mark sensor.
Guide on how to adjust the distance accuracy of the plotter.
To Next Page