i-Mark Digital Cutting Software
This software has been designed to manage the automation of the cutting process.
There are specic functions to execute kiss cutting, die cutting and creasing simulation.
It allows users to import graphics les in AI and EPS format.
The graphics have to contain two reference marks.
The dedicated video camera connected to the software, detects the crop mark in a fraction of a
second and adapts the cut path to the inclination and distortion of the print.
The software runs with the operating systems Windows 7, 8, 10.
Most of old Windows Seven and XP computers can be used, but not all of them.
The system is connected to the computer through a USB port.
Installation of the Graphtec driver
DO NOT INSTALL THE GRAPHTEC DRIVER !
You only have to install the driver if you want to install the other software supplied with the
plotter.
In this case, before you connect the plotter to the computer, you have to install the plotter driver
contained in the CD.
Inside the CD le <<Ce6000 drivers>> there are two version of the driver, one for Windows 32bit
and one for Windows 64bit.
Install the version related to your computer, most of the new computers are 64bit, to verify you
must open the computer icon on the desktop.
Select on the menu <<System's propriety>> to visualize the system characteristics.
Installation of the i-Mark software
Execute the installation's program imark-setup contained in the installation CD.
The setup program requires various conrmations for the installation of the software.
On some computers you could be asked the system administrator password to execute the
installation, in case you do not have this information, contact the technician who administrates
the system.
During the installation, the i-Mark program icon is created on the desktop and a shortcut in
the Windows Start Menu.
At the end of the install process you can launch the i-Mark software.
To Next Page
Loading...
