Insertion Flap
Suction Cup
Side paper guide
Blower
Blowers speed
regulation knob
Main switch
Rear paper guide
regulation knob
Side paper guide
adjusting knob
Magnetic Mat
Overview and adjustings
On the F-Mark there some knobs that allow some adjustment
depending on the paper size and type.
The side paper guide knob adjusts the opening of the side
giudes accordingly to the media width.
Keep the side guide loose on the media borders.
The rear paper guide knob allows to press the media on the
front of the media tray.
Keep the rear guide tigth against the sheets,
The blowers knob paper
allows to adjust the air stream of the
blowers.
A proper setting of the blowers speed helps the paper separation,
for adhesive media keep it at minimum or turn the blower off
forcing the knob counterclockwise.
For porous paper you may test different air stream levels, turns
the knob clockwise to increase the air stream. As a rule of the
thumb use a low air stream for curled prints and an higher level for
flat prints.
From the side view you can see Vacuum adjusting knob.
You can turn it clockwise to increase the vacuum force in case
the suction cup does not pick up the sheets.
Turn it counterclockwise when using thin paper and the suction
cups pick up more than one sheet.
To return to the default position turn the knob all clockwise and
then return back counterclockwise for two turns.
To Next Page
Loading...
