Cable connection
There are some USB cables and the power adapter that must be connected
before using the system.
Under the feeder there is an USB Hub fixed with a velcro tape for an easy
replacement.
The USB cable coming from inside the feeder is already connected, you
have to connect the cable from the optical camera and from the plotter.
For the CE6000-40 you can use the cable into the F-Mark accessory box.
for the CE6000-60 you have to use the USB cable from the plotter box.
The mini-USB cable goes to the computer, it is not necessary to install
drivers on the computer, you have just to wait until the system mathces the
different devices.
Depending on the computer you may have to wait few seconds up to some
minutes.
USB cable to the computer
USB cable to the plotter
USB cable to the camera
Internal USB
Bottom view
Power supply
To Next Page
Loading...
