GRAPHTEC F-Mark - Print and Cut Alignment

Print and cut alignment
in this case the cut line is 0.5mm too low
set 5 on the Y value to move it higher.
The
Y adjustment next to the preview allows you to set the
vertical position of the cut path.
By increasing the Y you move the cutting upwards.
By decreasing the Y you move the cutting downwards.
The
X adjustment allows you to set up the horizontal position of
the cut path.
By increasing the X you move the cutting rightwards.
By decreasing the X you move the cutting leftwards.
The change of position is in tenths of a millimeter.
The adjustment is necessary the rst time you install the cutter.
When you press the 'Start' button the values are memorized
and the following adjustments start from a ‘zero’ value.
Small variation can be inserted also during the processing; every
variation will be eective from the next sheet.
The ‘Calibration’ button allow a cut-peel-measure procedure to nd the proper alignment between printed graphics and cut path.
You have to insert manually one of the black adhesive sheets provided.
Lower the media lever, insert manually the sheet, rise the lever and press the key #2 on the panel.
The sheet must be in a central position between the push rollers
You can align it with the edge of the feeder to keep it straight.
If the black adhesive sheets for the calibration procedure were not
available you can print the le caliblack.pdf available among the
sample les.
13