GL820-UM-251-9370 5-10
5. INSPECTION AND CHECK PROCEDURES
(3) Press the [Left DOUBLE Arrow] key to display the menu shown below.
(4) Press the [START/STOP] key to measure the temperature.
(5) Wait until the "Finished" message is displayed, and then display the values as shown below.
Message
Conrm that this value is within
the above ratings after data has
been captured.
(6) Check that the level of measurement is within the above rating from the CH1 to the CH10.
(7) Press the [CH GROUP] key to display from the CH11 to the CH20.
Conrm that this value is within
the above ratings after data has
been captured.
To Next Page
Loading...
