Mounting SD CARD 2
CAUTION: To remove a SD card, push in gently to release the card before pulling.
The POWER LED blinks while GL840 is accessing the SD memory card.
* SD card must be unlocked.
< How to mount >
(1) Open the protective cover
to the SD CARD slot.
(2) Insert the SD memory
card until it clicks and is
firmly placed inside the
slot.
< How to remove >
(1) The SD memory card is
released by pushing
gently on the card.
Then, pull to remove the
card.
4
Internal memory
• The internal memory is displayed as SD1 or SD CARD1
• The internal memory is not removable.
A-type connector B-type connector
Connect with PC
GL840 midi LOGGER complies with the EMC Directive the supplied ferrite core is attached to the USB cable.
When connecting with the USB cable, the USB driver must be installed to the PC. For information about how to
install, refer to the "USB Driver Installation Manual" in the supplied CD-ROM.
To connect a PC using a USB
cable, attach the supplied ferrite
core to the USB cable as shown.
To connect GL840 and PC, use a cable with A-type
and B-type connectors.
USB cable
Ferrite core (Supplied)
To Next Page
Loading...
