GL900 Measurement Procedure
1.
Preparations : How to Make the Preparations Required for Data Capture
9
Measurement
object
In this section we will provide a simple explanation of the data capture
procedure: Preparations m Setup m Data Capture m Data Replay.
Voltage measurement is performed here.
Purpose of data capture : To measure the temperature of the target objects
Measurement points : 2 locations
Voltage range : 1V
Sampling interval : 10ms
Data save destination : Internal RAM
Number of capture points : 10000
Auto save : Internal flash memory
(Note: If data is saved only in the internal RAM, it is erased when the next data capture is started or when the power is turned off.)
1.Connect measurement object 1 to the CH 1 terminal.
2.Connect measurement object 2 to the CH 2 terminal.
3.Connect the AC power supply.
4.Turn on the power supply.
1 2
3
4
Screw-type terminal
can also be used.
To Next Page
Loading...
