Page 12
When lifting the sections, do not lift by the bodywork. Always use the
framework for gripping. The Junior Model has an integral lifting handle
built into the rear of the chassis.
It may be advantageous to release the brakes to assist in manoeuvring the
rear section on the floor or in the car.
HOW TO ASSEMBLE THE BUGGY
Assemble the Chassis - Ensure that both halves are square to each other.
Locate the front stainless steel draw bar into to corresponding slot on the
rear section. Slide the two halves together until the spring plunger locates
into a retaining hole on the draw bar. Three holes have been provided to
suit individual requirement for leg length.
Connect the Power Plug – The power plug connecting the front and rear
sections should be re-connected.
Replace Batteries – One at a time, place the batteries into the chassis. On
Junior model the terminals should be towards the centre. On Classic and
Classic SE Models the terminals should be towards the rear.
Ensure the Brakes are on – If the brakes have been released, ensure that
the brake locking levers have been returned fully counter-clockwise.
Replace Battery Cover – Carefully replace the battery cover and click
spring clips into position.
Replace the Seat – Line up the seat stem into the seat tube on the chassis
and allow it to drop into position. Re-fasten the seat locking bolt until
tight.
To Next Page
Loading...
Need help?
General
