GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors. 06/2010
16
Fix the engine mounts to the firewall using the screws supplied in the kit.
Assemble the parts for the throttle servo mount, and glue the completed mount in the
slots in the firewall. Install the servo when the glue has set hard.
Install the pull-cable carburettor linkage as shown in the photo.
The ignition unit for the G 26 should be screwed to the firewall on the left-hand side.
To Next Page
Loading...
