GRAUPNER Polaron User Manual

31 32
Tap the MISC icon on the main page to access the MISC mode and to program the Brushed
power motor, Warmer and ESC functions.
1) BREAK-IN
- The motor is operated and limited by the preset voltage for the preset time.
2) PROGRAM
- Programming requires 4 inputs: the voltage, the operating time, the delay time and the
number of cycles. After entering each data value, tap the Enter button. The charger
will repeat to load the motor using the preset number of cycles. The blue character
shows the current process.
◎ MISC PAGE (Addition function)
Tap the MISC icon to program the MISC
setup on the main page
Additional functions on CH1 or CH2 can also
be used.
Brushed motor setup
Connect the motor to a 4mm banana charge socket. Tap the MOTOR icon to access the motor
setup mode. This page has 3 menus.
The operating time is set by minutes and seconds
The operating voltage is set.
Tap the Enter button to check the operating time, volt-
age, and consumption current.
Setting the number of cycles (1-10 cycles)
Setting the operating voltage, the operating time, and the
delay time, for each of the 4 steps.
The operating cycle number.

GRAUPNER Polaron Specifications

General

Brand	GRAUPNER
Model	Polaron
Category	Power Supply
Language	English