GRAUPNER SEA FURY - Receiver and LiPo Battery Installation

GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors!
11/2011
- 11 -
The figures shows the retracted undercarriage.
Deals
Cut out the individual decals and name placards and apply them as shown in the
illustrations on the kit box.
Installing the receiver and LiPo battery
The first step is to connect the servo leads to the receiver; we recommend the
following sequence: speed controller to socket 1, left aileron servo to socket 2
(extension cable 100 mm), elevator servo to socket 3, rudder servo to socket 4, right
aileron servo to socket 5 (extension cable 100 mm), left landing flap socket 6
(extension cable 100 mm). Right landing flap to socket 7 (extension cable 100 mm),
retractable undercarriage to socket 8 (connecting cable); now do a test of all
functions using the radio control transmitter. Caution: After closing the G3.5
connector, the motor can start; do not touch the propeller!