GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors!
11/2011
- 3 -
opposite face. Make sure that no residual adhesive gets on your hands or on the
surface of the model. Immediately wipe of excess adhesive with wood pulp paper.
Caution: Cyano-acrylates must not come into contact with any part of your
body or the eyes; for this reason, we recommend that you wear protective
goggles when using this material. Store the adhesive out of the reach of
children. For safety reasons, use only the adhesive mentioned above. Please
observe the operating instructions and safety notices for the respective
accessories.
The wing
First apply adhesive (UHU ALL PURPOSE ADHESIVE Power) to secure the already
inserted aileron and landing flap hinges.
Then push up the ailerons and flaps until there is a gap of about 1 mm. After waiting
for them to dry, check whether the rudders are secure.
Unscrew the servo cover from the wing and fit in the servo. Cut off the excess part of
the levers and drill the desired hole for the servo lever to Ø 1.8 mm. Put the servo
into the neutral position, attach the servo level vertically, and screw it tight. Use
cyano-acrylate to glue the servo to the respective attachment tab.
Insert a string to pull the servo lead carefully into the wing. Attach a 100 mm
extension cable to the aileron servos. Screw on the servo cover and make the aileron
and landing flap connection. Connect the pushrods and glue in the horns of the
ailerons.
To Next Page
Loading...
