We recommend the following control surface travels, in each case measured at the
outboard end of the control surface:
Ailerons: 12 mm up, 6 mm down; brake setting: both ailerons 17 mm up.
Elevator: 3 mm up, 3 mm down.
And now all that remains is to wish you many hours of pleasure building and flying
your SPEED.
Parts List - SPEED
Part Description No. Material Size in mm
No. off
1 Motor bulkhead 1 Plywood 39 Ø x 4
2 GRP fuselage 1 GRP Ready made
3 Cheesehead screw 4 Steel M3 x 8
4 Washer 4 Steel 8 / 3.2 Ø
5 Elevator pushrod 1 Steel 1.2 Ø x 130
6 Tailplane 1 GRP Ready made
7 Elevator horn 1 Aluminium 3 Ø x 6
8 Countersunk screw 1 Steel M3 x 10
9 Countersunk screw 2 Steel M3 x 12
10 Servo well cover 1 GRP 40 Ø x 0.2
11 Wing 1 GRP / CFRP Ready made
12 Aileron horn 2 Brass 4 Ø x 13
13 Clevis 4 Steel M2 x 26
14 Aileron pushrod (machine screw) 2 Steel M2 x 26
15 Aileron servo well cover Pair GRP Ready made
16 Cheesehead screw 2 Steel M2 x 16
17 Cable tie 1 Plastic 188 x 4
18 Velcro tape, coarse 1 Plastic 100 x 25
19 Velcro tape, fine 1 Plastic 100 x 25
20 Pushrod retainer block 1 Plywood 12 x 12 x 4
To Next Page
Loading...
