GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors! 12/2011
Made in
Vietnam
12
Run a hot soldering iron along a steel ruler, somewhat smaller than drawn, to melt
through the cover sheet and separate it from the part.
Glue the tailplane and vertical stabiliser to the fuselage using UHU coll. As described
before, align the parts precisely, meaning that the tailplane is perfectly centred and at
a right angle to the longitudinal axis of the fuselage and that the vertical stabiliser is
glued at a right angle to the tailplane.
Secure the horizontal stabiliser against slippage until the glue hardens.
From the tail group, push the linkages for rudder, elevators, and tailwheel into the
guide holes and insert the clevises into the drill holes.
After the glue has set, screw on the tailwheel mount.
Fit the fuselage cover and fasten it to the
fuselage using transparent adhesive film.
To Next Page
Loading...
