GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors! 12/2011
Made in
Vietnam
13
Stick the tailwheel wire into the brass mount as shown in the photo and fasten it with
the M3 grub screws. Secure the grub screws using UHU schraubensicher thread-lock
fluid. Make sure that the tailwheel is fixed in place so that the model rolls straight
ahead when you start the model later on.
As already described at the start of the assembly instructions, stick the rubber
grommets and hollow rivets into the flange of the elevators/rudder (and the throttle
servo when an internal combustion engine is being installed) and screw them into the
little servo boards in the fuselage. For the attachment screws, pre-drill a pilot hole.
Elevator, rudder servo throttle servo
In the electric version, the drive battery is inserted using the little battery board.
Fasten the drive battery to the board as shown in the photo.
The board is then pushed into the
fuselage so that its nose extends into the opening in the bulkhead.
Now it is fastened to the floor of the fuselage using two M4 Allen screws.
To Next Page
Loading...
