GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
We reserve the right to introduce modifications. Not liable for printing errors! 12/2011
Made in
Vietnam
7
Now the rudder linkages are prepared. Adjust the length of the linkages so that the
rudders are in neutral position when the servo is in the centre position; for ailerons
and landing flaps a threaded part M2x23m.
Installation of the landing gear
Install the landing gear in the wings using four sheet metal screws as shown in the
photo.
The servos for the retractable undercarriage are installed in the wing halves using the
wooden parts shown.
The servo lever must be in neutral position when in the centre position. To achieve
this, briefly turn on the RC system.
The steering linkages must be adjusted so that the retractable undercarriage can be
locked in the extended and retracted positions.
To Next Page
Loading...
