GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler Ident. # 0059200 10.2008
25
Graupner
Order No. 9449
Instructions
VENTUS 2 cx
Model glider
for
slope-soaring and aero-tow
This model requires at least an eight-channel radio control system.
Specification
Wingspan approx. 5500 mm
Fuselage length approx. 1970 mm
Wing section HQ/W 3/13
Tailplane section HQ/W 0/10
Wing area approx. 104 dm²
Tailplane area approx. 9.4 dm²
Total surface area approx. 113.4 dm²
All-up weight according to
fittings, min. approx. 9500 g
Centre of Gravity approx. 107 - 111 mm back from the wing
root leading edge on both sides
Longitudinal dihedral approx. 1 - 1.5°
Be sure to read right through the instructions covering assembly and operation
of your model before you attempt to operate it for the first time. You alone are
responsible for the safe operation of your radio-controlled model. Young
people should only be permitted to build and fly this model under the
instruction and supervision of an adult who is aware of the hazards involved in
this activity.
If you have any questions regarding the safe operation of your RC model
aircraft, please turn to your local model shop in the first instance, as the staff
will be pleased to help you.
Radio-controlled model aircraft are very demanding and potentially dangerous
machines, and call for a high level of technical knowledge and skill from the
operator, together with a responsible attitude.
To Next Page
Loading...
Need help?
General