GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler Ident. # 0059200 10.2008
33
Material Typical joint Adhesive
Order No.
GRP to Fuselage to UHU plus endfest 300
plywood servo plate Order No. 950.43
GRP to Fuselage to UHU plus endfest 300
aluminium aero-tow coupling Order No. 950.43
GRP to Instrument panel to UHU plus schnellfest
plywood instrument binnacle Order No. 962
Areas of the fuselage which are to be glued should be rubbed down with fine-grit
glasspaper to remove any lingering traces of mould release agent. Carefully remove
all sanding dust. Aim at reducing the glossy surface to a matt finish, otherwise there
is no chance of a durable glued joint between the fuselage and other parts.
When using adhesives it is important to observe the instructions supplied by the glue
manufacturer. The main Graupner FS catalogue includes many other types of
adhesive.
When you are using solvent-based adhesives be sure to provide good ventilation in
your workroom.
Read the manufacturer’s instructions.
Radio control system
We particularly recommend computer radio control systems such as the mc-19S, mc-
22S, mc-24, mx-22 or mx-24.
Recommended servos:
Rudder DS 8077 Order No. 5149 1
reqd.
Elevator DS 3068 Order No. 5188 1
reqd.
Ailerons DS 3068 Order No. 5188 2
reqd.
Outboard wing flaps DS 3328 Order No. 5157 2
reqd.
Inboard wing flaps DS 3328 Order No. 5157 2
reqd.
Airbrakes DS 3068 Order No. 5188 2
reqd.
Aero-tow release DS 8077 Order No. 5149 1
reqd.
Wheel brake DS 8077 Order No. 5149 1
reqd.
We recommend the DS 24 FM 35 S receiver.
To Next Page
Loading...
Need help?
General